Description:

Tarend roller inspection conveyor 300 x 100 cm stainless steel with galvanised rollers

Roller inspection table 300 x 100 cm, equipped with lighting

• Aluminum rollers with a diameter of 50 mm, pitch 35 mm, spacing between rollers 20 mm
• Double platform for operators at the correct working height
• 1x waste and collection belt for Class 2 products
• 2x discharge belts for waste products
• 1x collection belt for waste products
• 1x conveyor belt for waste products, suitable for boxes up to 900 mm in height

The inspection table consists of a roller conveyor with aluminum rollers, each with a diameter of 50 mm and a pitch of 35 mm. This results in a maximum gap between the rollers of 20 mm. The rollers are 1,000 mm wide. On both sides, there is space for 4 operators, allowing up to 8 workers to operate the inspection table simultaneously. The maximum reach for each operator is 50 cm. The product is divided into two lanes by a guiding “roof” separator. The table is equipped with lighting to ensure proper product inspection.

Class 2 products are removed by a 250 mm wide conveyor belt located above the inspection table. This belt transfers the product at a right angle to a discharge belt, which moves the product to a Class 2 box provided by the customer. Defective and rotten products are removed by two belts located underneath the inspection table. These two belts transfer the products at a right angle to a discharge belt that leads to a box for defective and rotten products, also provided by the customer. All belts are frequency-controlled, except for the right-angle discharge belt for defective and rotten products.